Drain jetting for branch lines, interior drain systems, and residue-heavy drain runs that need a more complete cleaning pass.
What you are seeing
The drain gets cleared and works fine for a few weeks. Then it slows down again. Then it stops. Same line, same spot, same problem - because the cable opened a hole through the middle of the buildup but left the walls coated.
Drain jetting strips the residue off the pipe walls so the full diameter of the drain line is open - not just a narrow tunnel through the center of the grease or sludge.
Who this is for
Homeowners and property managers with a single drain line - kitchen, laundry, bathroom, or utility branch - where the clog keeps coming back because the buildup is too heavy for cable clearing to hold.
Drain jetting is for the specific branch line that keeps failing. It is a deeper cleaning for that drain run, not a whole-sewer service.
What you walk away with
The drain line gets jetted to its full diameter. The camera confirms the walls are clean - not just that water is passing through - so you know the clearing will actually last this time.
If the camera shows damage or a structural issue behind the buildup, you hear about it on site before any further work is recommended.
Problem
Standard drain clearing works by pushing a cable through the blockage. That opens a path and gets water moving again. But if the pipe walls are coated with grease, soap residue, sludge, or mineral scale, the cable does not touch that coating - it only breaks through the center. The walls stay coated, the opening narrows again with every use, and the same drain clogs in the same spot weeks later. That repeat-failure cycle is what drain jetting is built to break.
Drain jetting sits within the broader hydro jetting service family, focused specifically on individual branch lines and interior drain runs where residue on the pipe walls is causing repeat clogs.
The goal is to clean the pipe wall - not just the blockage point - so the drain stays open at full diameter instead of re-narrowing within weeks.
Solution
A cable clears the blockage. A jetting head cleans the pipe. The difference matters when the problem is not a one-time clog but a wall coating that keeps rebuilding itself. Grease, soap scum, mineral deposits, and sludge accumulate on the inside of drain pipes over months and years of daily use. Each layer narrows the pipe a little more until the drain fails. Cable clearing punches through that narrowed section, but the coating stays - and the narrowing starts again immediately.
Drain jetting sends a high-pressure nozzle through the line that fires water backward against the pipe walls as it travels. At 3,850 PSI, it strips the coating off and flushes the debris downstream. The pipe opens back to its full diameter, and the camera confirms the result before we leave.
Fit and situation bullets
Problem bullets
Customer Feedback
See what customers say after drain jetting — from the results on stubborn clogs and buildup to the honest assessment of whether the line is cleared for good or needs a maintenance schedule.
Leave a Review!Amazing experience! They are knowledgeable, kind, courteous and very thorough. Our clogged kitchen pipe was a bit of a challenge but they kept going and did everything they could to get it unclogged and they did it! They were very upfront with what caused the clog, gave us video recording of our pipes so we can see exactly what was done, double checked to make sure the pipes were clean and free of clogs and gave us steps on how to maintain the pipes moving forward. Highly recommend!!
I had an Emergency pipe back up AJ and Jake came snaked and got it all jetted out and cleaned up quick and for a really fair price! Anyone in need I would highly recommend
Very professional, quick and efficient work definitely would recommend
Highly recommend, very quick and easy to work with crew, drain cleaned my main sewer line professionally and well done.
This company is Awesome!!! Highly recommend that you call them for your drain cleaning and power washing needs! A++ in service, cost, and quality of work. Alex and Jacob completed drain work, patio cleaning, and filled in cracks in cement. The patio looks brand new! Thank you Alex and Jacob!!!
Alex was very good to work with. They were professional and punctual, working around my schedule. They were able to show me exactly before and after, even showing footage inside my pipes, which I have never seen before. I would recommend them.
Why Mountain West
3,850 PSI jetting capability
Clears lines 2 to 12 inches in diameter at 3,850 PSI and 8 GPM with 300 feet of reach. Enough pressure to strip grease and scale off the pipe walls of any standard residential or commercial branch line.
Camera rated to 200 feet
Scopes up to 200 feet of pipe with live footage review so you see the wall condition before and after jetting - not a verbal estimate of how clean the line is.
Jetting and camera on every call
Hydro jetting equipment deploys on every service call. No scheduling a second trip for jetting after a camera visit or vice versa.
20+ years combined field experience
Not a new crew experimenting with your drain line.
Licensed and insured
Licensed for sewer, drain, and drainage system work .
Drain jetting visits focus on one thing - cleaning the specific branch line that keeps failing, wall to wall.
You leave the visit with a drain line cleaned to full diameter, camera footage confirming the result, and a clear answer on whether the line will hold or needs further attention.
Jetting cleans the pipe wall. But if the camera shows a reason the buildup keeps forming - root entry, a pipe offset, a belly holding water, or structural damage - the next step moves past cleaning. These services cover what comes after jetting reveals a deeper problem.
Evidence
When the camera shows roots entering through a cracked joint or pipe break, jetting removes the growth but the entry point stays open. The roots will return unless the pipe is repaired at that location.
When the pipe has a belly, sag, or low spot that holds water and debris, residue collects there no matter how clean the walls are upstream and downstream. That is a structural issue, not a cleaning issue.
When the jetting reveals the branch line connects to a larger main run that also needs cleaning, the scope moves from drain jetting into main line hydro jetting or sewer hydro jetting.
Next Service RouteMain Line Hydro JettingFor whole-property drainage where the main run beyond the branch line also needs wall-to-wall pressure cleaning.
Next Service RouteSewer Camera InspectionFor property owners who need to see inside the sewer line before committing to repair, replacement, or a maintenance plan.
Next Service RouteDrain Camera InspectionFor a diagnostic camera look at the drain line when the priority is identifying the problem before deciding between cleaning, jetting, or repair.Scope and timing
Cost
Support
These are the quick answers most people want before they call, book, or decide on the next step.
Drain jetting solves repeat drain clogs caused by grease, sludge, soap residue, or mineral scale coating the pipe walls. It strips the buildup off the walls - not just punches through the center - so the drain stays open at full diameter for branch lines, interior drain systems, and residue-heavy drain runs that need a more complete cleaning pass.
Homeowners and property managers with a specific drain line that keeps clogging after standard cable clearing - usually a kitchen, laundry, bathroom, or utility branch where wall coating is causing the repeat failure.
The technician identifies the failing branch line, jets it at 3,850 PSI to strip the pipe walls clean, and cameras the line afterward to confirm full-diameter cleaning and check for hidden damage behind the buildup.
Know which drain keeps clogging, how many times it has been cleared, and how long each fix lasts. If prior camera work has been done on the line, mention what was found. That history helps determine whether jetting is the right first step or the line needs inspection first.
Related Reading
These follow-up reads stay close to this service and answer the pricing, warning-sign, process, and comparison questions that usually come next.
Cost Question
Cost Question: Breaks down the main price drivers, what usually changes the quote, and how to compare jetting scope before you book.
Service Explainer
What To Expect: Walks through the pre-jetting assessment, what the technician checks before starting, and which details matter.
Cost Question
Timing Help: Explains the decision point between cable clearing and jetting, and what usually tips the recommendation one way or the other.
